-E8-
NOTES:
•
Never place anything except a compact disc on the disc
turntable. Foreign objects can damage the unit.
•
Discs must be placed on the disc turntable one at a time.
BASIC CD PLAY
1. Press [FUNCTION] to select the “CD” function.
2. Press [CD DOOR OPEN], “OPEN” appears. The CD door opens.
COMPACT DISC PREPARATIONS
•
This unit is designed to play compact discs bearing the iden-
tification logo below. Discs that do not carry this logo may
not conform to the CD standard and may not play properly.
•
Fingerprints and dust should be carefully wiped from the signal
surface of the disc (glossy side) with a soft cloth. Wipe in a
straight motion from the center to the outside of the disc.
•
Never use chemicals such as record cleaning sprays, antistatic
sprays or fluids, benzene or thinner to clean compact discs.
These chemicals will permanently damage the plastic surface
of the disc.
•
Always place the compact disc on the disc turntable with the
label facing toward you. Compact discs can be played on only
one side.
•
To remove a disc from its storage case, press down on the cen-
ter of the case and lift the disc out, holding it carefully by the
edges.
•
Discs should be returned to their cases after use to protect them
from dust and scratches.
•
To prevent warping the disc, do not expose it to direct sunlight,
high humidity or high temperatures for extended periods of time.
•
Do not apply paper or write anything on either side of the com-
pact disc. Sharp writing instruments, or the inks used in some
felt-tip pens, may damage the surfaces of the disc.
•
This unit can play back the CD-R/RW that have recorded music
data as well. However, some CD-R/RWs can not be played back
depending on the recording conditions.
IMPORTANT INFORMATION
Sanyo CD players have built-in error compensation circuits to cor-
rect for minor manufacturing defects in a disc, There are limits,
however, to the amount of correction possible.
In some cases, the CD player may skip some tracks on a disc dur-
ing play. This problem may be caused by defects (such as scratches)
in the disc being played, which are too large for the error compen-
sation circuits to handle. If you encounter this problem, check the
operation of the CD player as follows, before having the unit serviced.
Play a new disc. If the CD player operates normally, the skip-
ping problem is most likely due to a defective disc.
CD PLAY
4.
Push the CD door back into position until it “clicks” into place.
The total number of tracks and total playing time on the disc
appear.
NOTE:
If the disc is loaded with the label facing toward the unit, or if a
badly scratched disc is loaded, “Cd” appears. If this occurs, load
the disc correctly or replace the damaged disc.
5.
Press [
I
]. Play starts from the first track.
The current track number and elapsed playing time are
displayed.
6.
Press [
N
] to end disc play.
When the last track has been played, the player stops
automatically.
If a disc is loaded, you can turn the unit on and begin play imme-
diately by pressing [
I
].
For 5-inch (12cm) or 3-inch (8cm) CD
1
2
3
6
5
3.
Place the disc with the label facing toward you on the disc
turntable.
(Place only one disc at a time.)
CAUTION:
Please do not place anything in front of the unit. In such a case,
the object in front of the unit may fall over or be knocked down.
AWM-660/US Eng page
4/16/04, 5:40 PM
9
