SANY SY95C, Руководство по эксплуатации и обслуживанию

Страница: 97 / 166

MACHINE OPERATION
4-35 SY95C Excavator OMM
5. Start the engine.
6. Push the hydraulic lockout lever to the unlock (open)
position.
0003907
Figure 4-81
7. Raise the work equipment and retract the arm toward
the boom. Drive the machine slowly.
0003908
Figure 4-82
8. Stop the machine when it travels over the rear
wheels of the trailer and toward the ramps.
9. Adjust the boom-arm angle between 90° and 110° (3)
and lower the bucket so that the flat surface is in
contact with the ground.
0003909
Figure 4-83
10. Drive the machine slowly onto the ramps.
11. Operate the boom and the arm slowly when the
machine is on the ramps. Allow the machine to
descend slowly until it comes in contact with the
ground.
Lifting the Machine
WARNING
• Make sure all lifting devices are in safe operating
condition and with sufficient capacity rating to
safely support the intended load.
• Never lift the machine with a person inside the
cab.
• Allow no one to stand close to or under a lifted
machine.
• Always lift with the longitudinal centerlines of the
upper structure and undercarriage parallel to
each other.
• Keep the hydraulic lockout control lever in the
locked (closed) position to prevent unexpected
movement of the machine.
Failure to follow these warnings could result in
death or serious injury.
NOTE: The lifting procedure applies to standard
machines. For operating weight of the machine,
see “Technical Specifications” on page 6-4.
0002341
Figure 4-84
1. Fully extend the arm cylinder and the bucket cylinder,
raise the dozer blade, and lower the boom.
2. Move the hydraulic control lever to the locked
(closed) position.
3. Turn the key to OFF and remove from the key switch.
4. Close the cab window and door.
5. Turn the battery disconnect switch to OFF.
6. Lock all doors and hoods. See “Doors, Filler Cap,
and Hood” on page 5-13.
7. Cover the exhaust opening to prevent contamination.
3