— 5 —
LED
Lits/flashes when the power is ON, the battery life is
low, or the tool approached to the live-wire cable.
Rubber ring
attachment
A position at which the included rubber rings are
mounted when attaching the product to a tool.
Sensitivity control
volume cover
Remove this when adjusting the sensitivity volume.
Sensitivity control
volume
Adjusts and controls the sensitivity volume. Rotating
the knob to “−” decreases the sensitivity while rotating
it to “+” increases the sensitivity.
Battery holder
Open this when replacing the batteries.
Power slide
Slide to turn the power ON/OFF.
Power indicator
Indicates the status of the power supply (ON: red,
OFF: black).
3-3 Installing Batteries
Be sure to install batteries before use after you purchase the
product.
“5-2 Replacing the Batteries”
When the battery is exhausted
If the power is turned ON with the low voltage of internal
batteries, you are warned with a buzz and LED as shown
below. Replace both of the batteries.
A buzz and LED illumination (for approx. 4 seconds)
LED
slowly flashing
* The battery status cannot be detected when the power remains ON.
Do not forget to cycle the power of the product before use and make
sure that the buzzer and LED does not show the status as above.