Sanwa DCL1200R, Инструкция по эксплуатации, Страница: 5 / 28

— 2 —
Function Signal Input Part Maximum Rated Input Value Maximum Overload Protection
1 5. Never use the meter near equipment which generates strong
electromagnetic waves or is charged.
1 6. Never use the meter if the meter or test leads are damaged
or broken.
1 7. Never use the meter with the case or battery lid removed.
1 8. During measurement, do not hold a place beyond the barrier
of the meter or the test pin side of the flange of the test leads.
1 9. To measure a voltage, first connect the black test lead to the
negative (–) or ground side. When disconnecting, the
positive (+) or non-ground side must be disconnected first.
10. During measurement, do not change the meter to another
function.
11. Before starting measurement, make sure that the function
and range are properly set.
12. Never use the meter when it is wet or with wet hands.
13. Be sure to use the specified type of test leads.
14. Never attempt repair or modification, except for battery
replacement.
15. Inspect the meter at least once a year.
16. This meter is for indoor use only.
1-3 Overload Protection
The maximum rated input value and overload protection have
been established for the signal input part of each function.
DC · AC 600Vrms
Voltage and current
input prohibited.
A
Clamp type
current sensor (CT)
AC 1200Arms AC 2000Arms
DC· AC 600Vrms
B and –
terminal