8
Instruction Manual for Biopür
1-888-726-8869
www.sanuvox.com
6. Hold the porcelain end-cap (with 4 pins) and carefully push the white
connector onto the four pins. The plug is designed so it can only be
installed one way. You may have to rotate the socket 90° to line up the
pins with the holes. The connector will fit into position
NOTE:
Too much force applied from the opposite end-cap may break
the lamp.
7. Replace the lamp
in the Biopür and hold it in place by
screwing back
the gray plastic support
. Be careful not to drop the screws in the
Biopür.
Once lamp is secure, lift the Biopür upright, back on its stand.
8.
Replace filters
in the following order:
a. TiO2 Catalyst
b. Activated Carbon Filter
c. HEPA Filter
d. Prefilter
Once
filters
are placed back inside the unit, turn latch
to keep filters in place.
9. Securely replace the cover:
To replace the unit front cover, first fit the
top of the unit into place and slowly press the bottom as to allow the
bottom clips to catch.
Now you can plug in and turn on your Biopür.
STEP 6
STEP 7
STEP 8
STEP 9
Step by Step Filter Kit Replacement
1. Turn off and unplug your Biopür.
Remove the unit cover:
To remove the front cover, grasp the bottom
of the unit and pull up and away from the unit. Once detached from the
unit, lift the cover upwards.
2. Once the Biopür is open, you will see the locking latch inside the Biopür,
at the top. Twist latch
to allow the filters to be removed.
Remove only
the replaceable filters (prefilter, HEPA filter and activated carbon
filter) and dispose of them.
CAUTION: Do not dispose of TiO2 catalyst.
STEP 1
STEP 2
3.
Prepare new filters.
Remove the contents from packaging and install
new filters by following step 4 to 6 of “Step by Step Setup & Installation”
on page 5.
STEP 3
