Sanuvox Technologies Inc, © 2021 All rights reserved. March 2021 EN v.8
Instruction Manual
Photos illustrating products are non contractual.
ASEPT.1X MAX
24/7 AUTOMATED PROTECTION UNIT AGAINST PATHOGENS
Medical Model
IMPORTANT SAFETY INSTRUCTIONS
READ AND SAVE THESE SAFETY INSTRUCTIONS BEFORE USING THIS PRODUCT.
Read and follow all instructions contained in
this manual before using the product. Failure
to comply with these instructions may result
in personal injuries or damage to the unit or
system.
1. Installation and servicing of this equipment
can be hazardous due to electrical components.
Only trained and qualified service personnel
such as certified electricians
should install,
repair or service equipment.
2. Untrained personnel can perform basic
maintenance functions such as replacing
UVC lamps. All other operations should be
performed by trained service personnel such
as certified electricians.
3. When working on the unit or system, observe
precautions in the literature, tags and labels
attached to the unit or system, and all other
safety precautions considered as best practices
in the industry.
4. When applicable, local regulation may
comprise more restrictive installation and/or
certification requirements. The afore mentioned
requirements prevail on those of this document
and the installer agrees to conform to these at
his own expense.
5. Follow all the safety instructions outlined in this
document and respect all local and national
codes applicable.
6. Never expose eyes or skin to ultraviolet
light from any source. Never start the
disinfection cycle with someone in the room.
Therefore,
before installing or performing
maintenance on the unit or system, TURN
OFF AND DISCONNECT the unit or system
from all power sources (there may be more
than one switch to disconnect).
CAUTION: Electrical shock may cause
personal injuries or possibly death.
7. UV rays may overtime damage or discolour
certain types of polymer or plastic.
8. When installing or performing maintenance on
the UV unit or system, it is recommended to
wear safety glasses and gloves. In order to
avoid reduced performance of lamp(s), do not
touch lamp glass without gloves.
9. Just like conventional fluorescent lamps, UV
lamps contain a small quantity of mercury: if a
lamp breaks, clean and dispose of with care.
UV lamps can be disposed/recycled after use in
the same way as any other fluorescent lamps.
Contact and follow your local and national
authorities’ specific instructions.
10.
Use only specified SANUVOX branded
replacement UV lamps with your unit or
system. Use of any other lamps will void your
warranty and can result in damage to the unit,
system and/or lamp(s).
11. Most UV units or systems are not waterproof.
DO NOT INSTALL OUTDOORS OR IN WET
LOCATION
unless specified otherwise.
12. Do NOT hang onto the device.
13. Risk of falling: the disinfection cassette may
fall when the rear lock is disengaged. Always
make sure it is in place.
14. Risk of rapid opening of the protective
envelope door when hung on the ceiling and
wall.
15. Risk of back pain when installing the
machine. Working at height with heavy
equipment can cause back injury. Make sure
you work in the most ergonomic position
possible.
16. Risk of falling during installation. Beware of
the risk of falling when working on a stepladder
during installation or maintenance.
SAVE THESE INSTRUCTIONS
Installation Date: _______________ Installed by: _________________
Installer Contact Info.: _________________________________________
REGISTER
YOUR WARRANTY
ONLINE AT
www.sanuvox.com
