Sanus 793795521965, Инструкция по эксплуатации

Страница: 7 / 16

7
≤ 16 mm
(5/8 in.)
40.6 - 61 cm
(16 - 24 in.)
2
Mount the Wall Plate
Wood stud mounting
Wood stud only
5.5mm
(7/32 in.)
13 mm
(1/2 in.)
For assitance in determining wall plate location, see Height Finder at SANUS.com.
Locate studs. Verify the center of the stud with an awl or thin
nail or use an edge to edge stud finder.
CAUTION:
Avoid potential personal injuries and property
damage!
Ù
Drywall covering the wall must not exceed 16 mm (5/8
in.).
Ù
Minimum wood stud size: common 51 x 102 mm (2 x 4
in.) nominal 38 x 89 mm (1½ x 3½ in.).
Ù
Minimum horizontal space between fasteners: 40.6 cm
(16 in.).
[03]
[03]
[08]
[07]
Drill pilot holes as illustrated.
CAUTION:
Improper use could reduce the holding power
of the lag bolt. To avoid potential injuries or property damage:
pilot holes MUST be drilled to a depth of 75 mm (3 in.), using
a 5.5 mm (7/32 in.) diameter drill bit.
Level wall plate [03] and mark hole locations.
CAUTION:
Improper use could reduce the holding power
of the lag bolt. To avoid potential injuries or property damage:
pilot holes MUST be drilled to a depth of 75 mm (3 in.), using
a 5.5 mm (7/32 in.) diameter drill bit.
Tighten lag bolts [07] only until the washers [08] are pulled
firmly against the wall plate [03].
CAUTION:
Improper use could reduce the holding power
of the lag bolt. To avoid potential injuries or property damage
DO NOT over-tighten the lag bolts [07].
75 mm
(3 in.)