6901-100147 <01>
1: Preparation
1- 1: New Installations
If you have purchased a Sanus Systems large VisionMount™ Full Motion Mount, but have not installed it, begin by following the
large VisionMount™ Full Motion Mount instructions. Replace
Cross Tube Installation
with
Step 2: Cross Tube Installation
of the
LAS1A instructions. When completed, refer back to this Instruction manual, starting at
Step 3: Install Extension Tubes
.
1- 2: Existing Installations
Disconnect all electrical connections
and release all cables from any cable tie
downs. Remove the safety bolt [
a
] as
shown.
[a]
All graphics in this section are generic and are only used to illustrate a procedure.
NOTE
[B]
[C]
HEAVY! You will need assistance with this step.
Lift the TV and arm assembly [
B
] off
the wall plate [
C
] as shown Lean the
assembly against a wall or other vertical
surface.
Using an Allen Key, loosen the six vise
assemblies [
D
]. Remove the lower cross
tube [
E
]; then, remove the upper cross
tube [
F
] as shown.
[E]
[F]
[D]
[D]
[25]