4 FR 1.0 - 04 2004
5/14
ADJUSTING THE MINIMUM GAP BETWEEN THE GRINDING WHEELS
This should be done after replacing the grinding wheels.
1. Plug the appliance in and run it empty.
2. Unscrew hexagon socket screw
(7)
on the dial
(4)
using a 2-mm Allen wrench.
Check that the dial
(4)
is free to rotate without turning button
(6)
.
3.
Turn button
(6)
anticlockwise until the grinding wheels come into contact (a slight
sound of friction will be heard) then back one notch in the reverse direction.
ATTENTION
This is a delicate operation, and prolonged contact between the grinding wheels
should be avoided, since this could damage them.
4. Turn the appliance off by placing switch
(13)
on
"0"
.
5. Without moving the button
(6),
place the dial
(4)
on the
"FINE"
position then tighten
the hexagon socket screw
(7)
fully home
.
6. Run the machine empty to check that the grinding wheels rotate without touching
each other on the finest setting. If this is not the case, repeat the above procedure.
