Structure of the machine
Sabrina Foam Light is made by the following parts:
•
Machine
body,
•
Accessory to spray foam, complete with its solution pipe for the connection
to the machine body,
•
Vacuum plastic hand tool and vacuum hose for the connection to the
machine body.
The machine body contains all the necessary devices for spraying foam and then
vacuuming:
•
The lower tank, containing the water and chemical solution used for
cleaning,
•
The upper tank, used to recovery the dirt sucked by the vacuum motor,
•
The solution pump and the vacuum motor, situated inside the lower tank,
•
The control panel for the pump and the motor,
•
The air compressor and the compressed air tank, located in the lower part,
•
The control panel for the regulation of foam,
•
The coupling for the incoming compressed air, located in the regulation
panel.
Preparation for work
To prepare the machine for work, do the following operations:
1. Insert the male quick disconnect coupling (located at the end of the solution
pipe coming out from the foam regulation panel) into the female quick
disconnect coupling (located at the pump outlet). In this way you allow the
solution sprayed by the pump to enter inside the lower part, where the foam is
generated.
2. Check that the valve at the foam outlet from the compressor is closed.
Connect the hose to spray foam to the coupling from which the foam goes out
