Santerno ASAC-0, Руководство пользователя

Страница: 5 / 12

ASAC-0 5/12
3.4 Outputs
3.4.1 Main Contactor Output
The Main Contactor output (terminals 13, 14) closes as soon as the soft starter receives a start command and remains closed while the
soft starter is controlling the motor (until the motor starts a coast to stop, or until the end of a soft stop). The Main Contactor output will
also open if the soft starter trips.
The Main Contactor output can be used to directly control a main contactor coil.
3.4.2 Run Output
The run output relay (terminals 23, 24) can be used to signal run status. This relay is normally open.
The relay operates when the soft start is complete, the bypass relays are closed and full voltage is being applied to the motor. The
relay can be used to operate a contactor for power factor correction capacitors, or to signal soft starter run status to an automation
system.
3.5 Electrical Schematics
Soft starter installed with fuses, a main contactor and overload protection.
6/T3
4/T2
2/T1
5/L3
3/L2
1/L1
13
14
M
K1
23
24
K1
03238.
F
M Motor (three phase)
K1 Main contactor
13, 14 Main contactor output
23, 24 Run contactor output