Santerno ASAB, Инструкция по эксплуатации, Страница: 7 / 12

Elettronica Santerno S.p.A.
S.S. Selice, 47
– 40026 Imola (BO) Italy
Tel. +39 0542 489711
– Fax +39 0542 489722
www.santerno.com, sales@santerno.com
- 15G0078B130 -
USB MODULE
INSTRUCTIONS
FOR ASAC-0/ASAC-1/ASAB
Issued on 15/06/12
R. 01

This manual is integrant and essential to the product. Carefully read the instructions contained herein as they provide
important hints for use and maintenance safety.
 This device is to be used only for the purposes it has been designed to. Other uses should be considered improper and
dangerous. The manufacturer is not responsible for possible damages caused by improper, erroneous and irrational uses.

Elettronica Santerno is responsible for the device in its original setting.

Any changes to the structure or operating cycle of the device must be performed or authorized by the Engineering
Department of Elettronica Santerno.

Elettronica Santerno assumes no responsibility for the consequences resulting by the use of non-original spareparts.

Elettronica Santerno reserves the right to make any technical changes to this manual and to the device without prior
notice. If printing errors or similar are detected, the corrections will be included in the new releases of the manual.

The information contained herein is the property of Elettronica Santerno and cannot be reproduced. Elettronica Santerno
enforces its rights on the drawings and catalogues according to the law.
Contents
1. Important User Information ...................................................................................................................................... 2
2. Introduction ................................................................................................................................................................ 2
3. Installation .................................................................................................................................................................. 2
4. Connection ................................................................................................................................................................. 3
5. Configuration ............................................................................................................................................................. 3
6. Specifications ............................................................................................................................................................ 5