Santec PIANA I 4565HN10, Быстрый старт

Страница: 4 / 5

Installing On Solid/Hard Surface
Measuring the Mounting Hardware Posts
Measure the dimensions carefully, mark the four screw hole positions by using
the Mounting Hardware Post.
Using a drill, pre-drill the holes.
Insert Anchors into the wall.
Secure the Mounting Hardware Posts by tightening the Screws into the An-
chors.
After assembling the first mounting Hardware Post at the desired height, slip one side
of the towel Bar into the Mounting Hardware Post and the second post on the wall.
mark above ,below, right, and left of the post with a pencil and remove the towel bar
assembly. Connect the two lines to find the center.
Place the center of the other Mounting Hardware Post over the mark and check with a
level to make sure the height of both is the same. When level and centered, mark the
screw hole positions.
0 3
TOWEL BAR & TOILET PAPER HOLDER