The measurements shown are for reference only. Products and specifications shown are subject to change without notice.
www.santecfaucet.com | P: 310.542.0063 F: 310.542.5681
2/6
NOTE: The length of threaded pipe coming out from the finish wall should be no
longer than 1/2”.
WARNING: Do not use excessive force when threading the spout.
- Wrap the pipe threading for the spout with teflon tape. Then, thread the spout onto
the pipe until it is secured with the spout facing downward.
SPOUT INSTALLATION
1
Thread the bonnet nut, all thread, and insert the broach assembly
onto the valve and lightly tighten assembly with a 1” plumber’s
socket Wrench.
2
Thread the escutcheon completely onto the all thread ensuring
the broach properly engages the handle (orientation of the handle
is not important at this point)
4
Rethread the bonnet nut,all thread, and insert the broach
assembly back onto the valve and snugly tighten the assembly
with a 1” plumber’s socket wrench.
5
Ensure the valve is in the closed position and align the handle to
its respective “OFF” Position on the trim.
6
Thread the escutcheon on the handle onto the all thread and
broach assembly ensuring the handle position remains in the
closed position.
3
Measure the distance remaining between the handle base and
wall, remove all trim items from the valve, and cut the excess
distance from the end of the all thread and broach assembly.
HANDLE INSTALLATION
Diagram A
Bonnet Nut
Bonnet Nut
Finished Wall
All Thread
