Installation Instruction
Pressure Balanced Control
with Diverter
Please read the instructions completely before beginning the installation.
Pressure balanced control
Model Number:
39
3
5
CI
Rev
1
0
/20
20
The measurements shown are for reference only. Products and specifications shown are subject to change without notice.
www.santecfaucet.com | P: 310.542.0063 F: 310.542.5681
1/
3
Pressure balanced control
Model Number:
393
5
CX
INSTALLATION
NOTE: Failure to follow these instructions may cause damage or improper operation to the unit and nullify the warranty.
ROUGH IN
- Make sure the water supply is off.
- Secure the valve firmly against the stud. Make sure the 1/2” shower outlet is in the up position.
- Make sure to flush or raise grouting on the tiled wall surface.
- Adjust the All Thread depth against the Teflon Washer and Limit Stop.
Screw the All Thread against the Teflon washer until it is pressured gently against each other.
- Tighten firmly the Lock Nut against the Lock Plate.
- Position the valve using the dimension shown in the illustration B.
FLANGE WASHER HANDLE FLANGE HANDLE BELL HANDLE
3.00”
All Thread
Broach
Extension
Lock Nut
Lock Plate
Trim Plate
S
T
Diverter Rod
Diverter Knob
Diverter Rod O-Ring
ILLUSTRATION B
