2/3
1
Install Gun Lock
2
Install Butt Plate
3
Adjust the parts
4
Mark the holes
6
Tighten the screws
Install gun lock on one leaf of the hinge (part
No. SC-9302) using the 2 screws and lock
washers provided with the SC-1 gun lock.
Install butt plate on L-bracket (butt plate No. SC-
1900 and L-bracket No.SC-9903), as illustrated,
using allen screws and
sheetmetal screws, provided
with the butt plate.
Slightly tighten all bolts and screws so you can
still move parts around. Put your actual weapon
in the gun lock and butt plate and position your
whole assembly at your intended location. Adjust
hinge height/angle and butt plate position until
your weapon is properly lined up.
Important: Weapon must have some (1/16") free
play in gun lock for gun lock mechanism to
operate correctly. Weapon should not press
against gun lock door.
Mark screw locations on wall/ oor. Check back
side of wall for fuel or electric lines.
5
Drill and install
Place your weapon in the setup, test and retest
your installation by repeatedly inserting and
removing the weapon from the assembly. When
satis ed, tighten all screws and test again.
B
Note:
Depending on your installation, the
butt plate can be attached directly
onto the oor, using sheetmetal
screws (in case of sheetmetal oor)
or wooden screws (in case of wooden
oor). In this case do not use the L
bracket.
A
SC-916-1
Fixed Pump Shotgun Rack with SC-1 Lock
Drill your holes and install assembly.
