ENGLISH
5
4. Route the housing into the downtube
access port until it exits the non-drive
side access port at the head tube. There
should be a gentle bend in the housing
from the seat stay to the downtube.
5. Make sure the housing is long enough to
allow the handlebar to rotate 180 degrees
to each side without pulling the housing
from the rear derailleur cable stop or
the shifter.
6. Use a cable cutter to cut the housing to
the correct length (not pictured).
Tip: use pliers to round out the housing
after the cut, as oval-shaped housing can
apply unwanted friction on the cable. You
may also use a pick inserted inside the
housing to round the hole.
