PREPARATION
POWER SOURCE
This STEREO CD PLAYER operations on 6 “C” size (UM-2) batteries (Not included) or from an AC-DC 9V adaptor
(Not included).
A. BATTERY INSTALLATION
1.
Turn over the unit and remove the
Battery Cover Screw (13)
to open the
Battery Cover (12)
.
2.
Install 6 “C” (UM-2) size batteries into the compartment, according to the polarity diagram on the bottom of unit.
3.
Close the
Battery Cover (12)
and assemble the
Battery Cover Screw (13)
.
To Install or Remove Batteries
REMOVE:
Turn screw counterclockwise to open.
TIGHTEN:
Turn screw clockwise to close.
BATTERY PRECAUTIONS
Follow these precautions when using battery in this device:
1.
Use only the size and type of battery specified.
2.
Be sure to follow the correct polarity when installing the battery as indicated in the battery
compartment. Reversed battery may cause damage to the device.
3.
Do not mix different types of batteries together (e.g. alkaline, rechargeable and standard
(carbon zinc) or old batteries with fresh ones.
4.
If the device is not to be used for a long period of time, remove the battery to prevent damage
or injury from possible battery leakage.
5.
Do not try to recharge battery that is not intended to be recharged they can overheat and
rupture (Follow battery manufacturer’s directions).
6.
Do not dispose of batteries in fire, batteries may leak or explode.
B. AC OPERATION
This unit may also be used with an AC adaptor (not included). When the AC adaptor is connected to the
DC Input
Jack
(11)
, the batteries are automatically disconnected. Please make sure to use an AC adapter with a rating of 9
Volts DC, 800mA with the following polarity.
If you are using a universal adapter with an output polarity switch or polarized plugs, be sure to set the polarity to “
+
”
HAND MIC INSTALLATION
1
.
Insert the MIC Stand into the
MIC slot (16)
.
2.
Insert the Hand MIC into the MIC Stand as shown.
3.
Plug in MIC 1 into the
MIC 1 Input Jack (9)
.
4.
Plug in MIC 2 into the
MIC 2 Input Jack (4)
.
5
