23
EN
ENGLISH
Manual setting
Settings
Description
Factory setting
I
(cleaning mode)
Stop function
Stops the flush function for cleaning. Flush function can be ena
-
bled again after cleaning. Automatic activation after 3 minutes.
3 minutes
II
Light mode
Person detection by light bar in sensor field can be switched
ON
or
Off.
The sensor field blinks if voltage is supplied by battery.
ON
III
Power source
There is a choice between
network
or
battery mode
.
Service period extended by battery mode.
Sensor field only blinks when urinal is entered.
Power pack
IV
Color
Setting of light color, selected can be:
RED/GREEN/BLUE
BLUE
V
Main flush time
Flush time after use, flush times of 3, 4, 5, 6 and 8 seconds
can be set.
4 seconds
VI
Dynamic flush
Water save mode, e.g. for stadiums, schools, restaurants,
cinemas, theatres…
Flush time reduced to 2.5 seconds if min. 3 users use the urinal
at a time distance of less than 1 minute. Switches automatically
back to normal when user interval is larger than 1 minute.
OFF
VII
actory setting
Resets the functions II, III, IV, V and VI to factory setting.
Keep the sensor field covered by hand at a distance of
about 4 cm. After a few seconds the actuator plate starts
blinking
RED
, then remove the hand.
Now, the cleaning mode is activated for 3 minutes. The
sensor field blinks
RED
two times every 6 seconds.
The cleaning mode is deselected automatically after
3 minutes or by a repeated covering of the sensor field
until it starts blinking
RED
quickly.
I Cleaning mode
3 minutes
6 sec.