7
Getting started
First find a location for your new HD radio,
1. The FM telescopic antenna is already installed. Dipole Antenna and
installing tool are in cluded for better reseption.
2. Connect the AM loop antenna into external AM loop antenna terminal
on the back of the unit.
3. Plug the AC power cord into the socket located on the back of the
unit. Please ensure that the plug is pushed fully into the socket.
4. Plug the other hand of the AC power cord into a wall socket and
switch on the wall socket if needed. (NOTE: You may hear a loud
“POP” when power is connected. Do not be alarmed.)
Important:
1. The AM loop antenna should be located at least 50 cm away
from the receiver to avoid possible interference.
2. Do not touch Power/Control knob on the radio while plug in
AC power.
Setting the clock
Clock setting can be done when the receiver is on or in Standby Mode
(power off).
1. Press “Enter” or “Power /Control knob” button. The display should
not read “Setup Clock Set”.
2. Press “Enter” or “Power /Control knob” button again. Display should
read “Clock Set” and the hour should begin blinking.
3. Press “Tuning” Up/Down or rotate “Power /Control knob” to select
Hour then press “Enter” or “Power /Control knob” button again to
complete hour setting.
4. Use same procedures to complete minute, AM or PM, date,
month and year. Press “Enter” or “Power /Control knob” button
to complete Clock Set.
20070524_HDR-1_381QB0SB-A_GB.p65
2007/5/24, ¤U¤È 03:20
10
