QDS-6100/6200 - User Guide, Rev. 1.0
// 38
7.13.
Switches and Jumpers
The product has several jumpers which must be properly configured to ensure correct operation.
Figure 24: Jumper Connector
For a three-pin jumper (see Figure 24), the jumper setting is designated ‘‘1-2’’ when the jumper connects pins 1 and 2.
The jumper setting is designated ‘‘2-3’’ when pins 2 and 3 are connected and so on. You will see that one of the lines
surrounding a jumper pin is thick, which indicates pin No.1.
To move a jumper from one position to another, use needle-nose pliers or tweezers to pull the pin cap off the pins
and move it to the desired position.
7.13.1.
Panel Power Selection (12V 5V 3.3V)
The 2.0 mm pitch "Panel Power Selection" jumper can be used to select LVDS / eDP panel power voltage.
Figure 25: Panel Power Selection (12V 5V 3.3V)
Table 31: Pin Assignment Panel Power Selection (12V 5V 3.3V)
Jumper 1 Position
Description
Pin 1-2 Pin 3-4 Pin 5-6
X
-
-
Panel Power = +3.3 V
-
X
-
Panel Power = +5 V
-
-
X
Panel Power = +12 V
“
X’’ = Jumper set (short) and ‘‘-’’ = jumper not set (open)
