KSwitch D4 MM Managed Ethernet Switch - Preliminary User Guide, Rev. 0.9
// 30
5/
Mounting
Before installing the switch consider the required orientation of the switch within the installation environment and
access to connectors.
Mount leaving a clearance of 20 mm around the switch, to ensure proper operation and to
prevent the switch from overheating.
5.1.
DIN-Rail Mounting
To mount the switch on a DIN-Rail, perform the following:
1.
Fasten the DIN-Rail clip on the switch in the upper position (Figure 13) using the three screws (length 5 mm & size
M3) provided.
Figure 13: DIN-Rail Clip
2.
Hook the top of the DIN-Rail clips over the DIN-Rail and push the bottom of the switch towards the DIN-Rail until
the Din-Rail clip snaps into place.
5.2.
DIN-Rail Removal
To remove the switch on a DIN-Rail, perform the following:
1.
Push the switch down to free the bottom of the DIN-Rail clip from the DIN-Rail.
2.
Rotate the bottom of the switch away from the DIN-Rail.
3.
Unhook the top of the DIN-Rail clip from the DIN-Rail by lifting upwards.
