S&T kontron KSwitch D3 UMP, Руководство пользователя

Страница: 29 / 36

KSwitch D3 UMP Unmanaged PoE Ethernet Switch - User Guide, Rev. 1.0
www.kontron.com // 29
7/ Technical Specification
The KSwitch D3 UMP supports up to 10-ports.
7.1. Hardware Specification
Table 5: Hardware Specification
10-Port
Network
Operating Store and forward, L2 wire-speed/non-blocking switching engine
MAC addresses 16K
Packet Buffer 4 Mbits
Switching Fabric/Back
Plane Up to 5.6 Gbps
Ethernet Connectors (RJ45 Copper & Fiber)
RJ45 Copper Ports Up to 8x 10/100 Mbps
Up to 2x 10/100/1000 Mbps Up to 8x 10/100 Mbps
Fiber Ports Up to 2x 1000 Base SFP slot
RJ45 Copper Ports
Speed Up to 8x 10/100 Mbps
Up to 2x 10/100/1000Mbps
MDI/MDIX Auto-
crossover Support straight or cross wired cables
Auto-negotiation/Duplex 10/100/1000 Mbps speed auto-negotiation, full & half duplex
Ethernet Port Protection 1.5 KV VRMS 1 minute (Hipot), 2 KV surge immunity on RJ45 copper ports
PoE
IEEE 802.3af/at (15.4/30 Watt), PoE/PoE+
Fiber Ports
Port Types supported Up to 2x 1000 Base SFP Slot
Fiber port connector LC/RJ45 connector for fiber ports
Optimal fiber cable Typical 50 or 62.5/125 μm for multimode (mm)
Typical 8 or 9/125 μm for single mode (sm)
Protocols and Standards
IEEE 802.3, IEEE 802.3x, flow control, back pressure, TCP/UDP, IEEE 802.3af/at
Power
Power Input Redundant power input, removable 6-pin DC terminal block
Input Voltage Range 24 VDC to 48 VDC
Reverse Power
Protection yes
Transient Protection > 15, 000 W peak
Power Consumption 10 W (without PoE load)
8x 30 W, total power budget, 240 W
Indicators
Power Status Indication Power input status
Ethernet Port Indication Link & speed