KISS 2U Short V3 - User Guide, Rev. 1.1
// 35
3.
Pulling the cover out slightly as shown in Figure 24, releases the cover’s centering and fixing brackets (Figure 19
pos.3 and pos. 4) from the retaining brackets of the chassis (Figure 20, pos. 1).
Figure 24: Pull and release the cover
4.
Lift the cover up (on the rear edge) to remove the cover as shown in Figure 25.
Figure 25: Removing the cover
5.
To close and secure the cover, proceed in the reverse order (step 4 to step 2).
To close properly secure using all knurled screws: one front side and three rear side.
7.2.
Accessing Internal Components
This chapter contains important information on working safely with internal components. Follow these instructions
when handling internal components and observe the corresponding safety instruction included in Chapter 1/: General
Safety Instructions for IT Equipment.
Energy hazards-240 VA present inside the chassis!
Before removing the top cover. Switch off the product properly using the power switch on
the front side and disconnecting the power cable from the mains power supply.
Activities requiring internal access of the product must be performed by trained personnel
aware of the associated dangers!
ESD Sensitive Device!
Follow the safety instructions for components that are sensitive to electrostatic discharge
(ESD). Failure to observe this warning notice can result in damage to the components.
Consult the documentation provided by the expansion card’s manufacturer for instructions
before installing/removing an expansion card.