KISS 2U Short V3 - User Guide, Rev. 1.1
// 34
7/
Assembly
No special tools are required to open the KISS 2U Short V3. Before opening the KISS 2U Short V3 observe the
instructions within this chapter.
Energy hazards-240 VA present inside the chassis!
Before removing the top cover. Switch off the product properly using the power switch on
the front side and disconnecting the power cable from the mains power supply.
Recommended intended used is closed and locked
Only when the cover is secured is it ensured that the operator does not have access to the
internal parts, loaded with hazardous energy. To close properly secured using all knurled
screws: one front side and three rear side.
7.1.
Opening and Closing the Cover
To open the cover, perform the following:
1.
Switch off and disconnect the product from the mains power supply.
2.
Loosen the cover’s one knurled screw on the front side (Figure 22) and the three knurled screws on the rear
side (Figure 23 ).
Figure 22: Loosening knurled screw on the front side
Figure 23: Loosening knurled screws on the rear side