KISS 2U Short V3 - User Guide, Rev. 1.1
// 42
9/
Starting Up
Before staring up observe the instructions in Chapter 1: General Safety Instruction for IT Equipment and read the
instructions and warnings in this chapter.
Easy Access to Power Cable and Power Connectors
The power cable must always remain easily accessible. If the end environment restricts
access to power cable, disconnection must be guaranteed using a separate cut-off fixture.
Energy hazards-240 VA present in the chassis
To switch off the product properly and ensure no energized internal parts, switch off the
product using the power switch on the front side and disconnecting the product’s power
cable from the input power socket or the mains power supply.
Intended used is closed
Use only when the cover is closed using the kurnled screws (one front side and three rear
side) to ensured that the operator doesn’t have access to energized internal parts.
Ensure that the mains power supply socket (power outlet) is properly grounded and the
power cable is in perfect condition with no visible damage.
The rated mains voltage range must agree with the voltage specified on the type label.
9.1.
Connecting the Power Connection
The input power socket is located on the rear side. To connect the power and start up, proceed as follows:
1.
Connect the ends of the supplied AC power cable to the corresponding sockets:
a.
Input power socket (Figure 32)
b.
Mains power supply socket using the electrical plug for the region.
Figure 32: Input power socket
2.
Unlock the front access panel (Figure 7, pos. 3) and press the power button (Figure 9, pos. 7).
3.
Close and lock the front access panel.
4.
The power LED illuminates green. (Figure 7, pos. 2 and Figure 11, pos. 1)
Do not disconnect the power from the product while the product is powered up!
Performing a forced shut down can lead to loss of data or other undesirable effects!
Input power socket
