S&T kontron KBox C-103-CFL Series, Руководство пользователя

Страница: 49 / 125

KBox C-103-CFL-x - User Guide, Rev. 1.0
www.kontron.com // 49
6.1. Top Cover
The pictures in this section correspond to a KBox C-103-CFL-2 system.
The cover description can be applied to all system variants, under consideration of the
different mechanical specifications of the KBox C-103-CFL; refer to the section 12.1
“Mechanical Specifications of the KBox C-103-CFL”.
When used as intended the KBox C-103-CFL is to be operated only in closed condition.
Only when the right side cover is fixed with the screws (Figure 21, pos. 2) and top cover is
properly installed and secured with the knurled screws (Figure 11, pos. 2) on the front side, it
is ensured that the user doesn’t have access to the internal components of the KBox C-103-
CFL during operation.
The cover will be fixed to the chassis using the centring bracket at the rear side of the cover (Figure 34, pos. 3) and
the fixing bracket with captive knurled screws at the front side of the cover (Figure 34, pos. 5).
When inserting the cover, make sure that:
 At the rear: the centring bracket (Figure 34, pos. 3) is inserted properly into the corresponding cover retaining
bracket of the chassis (Figure 39, pos. 13).
 At the front side: the fixing bracket with captive knurled screws of the cover (Figure 34, pos. 5), is matching
properly over the cover retaining bracket on the front side (Figure 39, pos. 1).
The fixing bracket with captive knurled screws (Figure 34, pos. 5) secures the top cover on the front side (Figure 11,
pos. 2).
Figure 34: Inside of the top cover with centering and fixing brackets
1 Inside of the top cover
2 Rear part of the top cover
3 Centering bracket (on the rear side)
4 Air exhaust openings
5 Fixing bracket with knurled screws on the front side
2 3
1
4
5