KBox C-103-CFL-x - User Guide, Rev. 1.0
// 73
10/
Maintenance and Cleaning
Equipment from Kontron requires only minimum servicing and maintenance for proper operation.
For light soiling, clean the KBox C-103-CFL with a dry cloth.
Carefully remove dust from the surface of the cooling fins of the chassis using a clean, soft brush.
Stubborn dirt should be removed using a mild detergent and a soft cloth.
Do not use steel wool, metallic threads or solvents like abrasives, alcohol, acetone or
benzene for cleaning the KBox C-103-CFL.
10.1.
Replacing the Lithium Battery
If your KBox C-103-CFL is equipped with the optional lithium battery (CR 2032, 3V, internally accessible), and you have
to replace it, please proceed as follows:
1.
Open the topside access cover as describes in chapter 6.2 “Opening and Closing the KBox C-103-CFL”.
2.
The battery is located on the side of the baseboard that faces to the cooling fins (see Figure 55).
Figure 55: Location of the optional Lithium battery
3.
Remove the lithium battery from the holder by pulling it outwards.
4.
Place a new lithium battery in the battery holder.
5.
Pay attention to the polarity of the battery: the plus pole must face to the top side, the minus pole to the bottom
side of the battery holder (see Figure 56).
Figure 56: Lithium battery polarity
6.
The lithium battery must only be replaced with the same type of battery or with a type of battery recommended
by Kontron Europe.
7.
Close the top access cover.
-
Содержание Kontron KBox C-103-0
Страница 2: ...KBox C 103 CFL x User Guide Rev 1 0 www kontron com 2 This page has been intentionally left blank...
Страница 28: ...KBox C 103 CFL x User Guide Rev 1 0 www kontron com 28 Figure 12 Block Diagram KBox C 103 CFL x...
Страница 124: ...KBox C 103 CFL x User Guide Rev 1 0 www kontron com 124...