KBox B-201-CFL - User Guide, Rev 1.3
// 43
Figure 29: Inserting the Band
5.
Double back with the flexible hook and loop band and feed the rough end through the band’s D-ring. Pull the
band through the D-ring and press approximately 30 mm to 50 mm of the self-gripping sides together to
form a loose loop. Lift the bottom part of the loop to meet the top part to form a gap between the band and
the VESA 100 mounting frame, as shown in Figure 30.
Figure 30: Positioning the Power Supply
6.
Slot the power supply, with the 3-pin AC connector facing towards the bottom of the VESA 100 mounting
frame, into the gap made in step 5 and feed the power supply between the left and right aligning brackets.
Push down until the power supply rests on the two holding brackets at the bottom.
7.
Secure the power supply by opening the self-gripping sides and pulling the band away from the D-ring as
far as possible and re-securing the band tightly.
Figure 31: KBox B-201-CFL and Power Supply Mounting Position
D-ring
Threading slots on the left and right aligning brackets
Two holding brackets
Gap for power supply
