COMe-cHL6 / User Information
COMe-mBT10 User Guide
// 29
4.2.
Secure Digital Card
The COMe-mBT10 supports an SDIO Interface to be used for micro/mini/standard SD Card sockets. Following SD Cards
are validated from Kontron and recommended for use:
swissbit® S-200U & S-300U Series Industrial microSD Card
»
compliant to SD Card specification 2.0
»
Wear Leveling of static and dynamic data
»
High reliability (MTBF >3,000,000 hours, > 10,000 insertions)
»
Extended or Industrial Temperature range
»
up to 25MB/s data transfer speed
Delkin Devices Inc. MicroSD
»
compliant to SD Card specification 2.0
»
Wear Leveling and ECC
»
High reliability (MTBF >2,000,000 hours, > 2,000,000 write/erase cycles)
»
Industrial Temperature range
»
up to 17MB/s data transfer speed
Order information
Density
Manufacturerer & Part.No.
Temperature range mSD-SD Adapter
1GB SD1.1 swissbit SFSD1024N1BN1TO-I-DF-151-STD
-40°C to 85°C
No
2GB SD1.1 swissbit SFSD2048N1BW1MT-E-ME-111-STD
-25°C to 85°C
No
2GB SD1.1 Delkin SD02GHMSH-S2047-B
-40°C to 85°C
No
2GB SDHC Delkin SD02GHMSH-S2000-B
-40°C to 85°C
Yes
4GB SDHC swissbit SFSD4096N1BW1MT-E-DF-111-STD
-25°C to 85°C
No
4GB SDHC Delkin SD04GHMSH-S2647-B
-40°C to 85°C
No
4GB SDHC Delkin SD04GHMSH-S2600-B
-40°C to 85°C
Yes
8GB SDHC Delkin SD08GHMSH-S2647-B
-40°C to 85°C
No
8GB SDHC Delkin SD08GHMSH-S2600-B
-40°C to 85°C
Yes
4.3.
S5 Eco Mode
Kontron’s new high-efficient power-off state S5 Eco enables lowest power-consumption in soft-off state – less than 1
mA compared to the regular S5 state this means a reduction by at least factor 200!
In the “normal” S5 mode the board is supplied by 5V_Stb and needs usually up to 300mA just to stay off. This mode
allows to be switched on by power button, RTC event and WakeOnLan, even when it is not necessary. The new S5 Eco
mode reduces the current enormous.
The S5 Eco Mode can be enabled in BIOS Setup, when the BIOS supports this feature.
Following prerequisites and consequences occur when S5 Eco Mode is enabled
»
The power button must be pressed at least for 200ms to switch on.
»
Wake via Power button only.
»
“Power On After Power Fail”/“State after G3”: only “stay off” is possible
Downloaded from
