Sandstrom S60GHB13, Инструкция по эксплуатации

Страница: 16 / 20

16
Using an External Outlet Vent
• This cooker hood can be vented externally using a exhaust hose and fixings (not supplied).
• Only use smooth pipes or flexible hoses (not supplied) made from
non-flammable materials for the extraction ducting. To achieve
the greatest possible air extraction with the lowest noise level,
please note the following:
• To ensure efficient air extraction, the diameter of the exhaust
ducting should not be less than 120mm for maximum extraction
and quietest operation 150mm diameter tubing should be used.
• If flat ducting is being used, the cross-sectional area must not be
smaller than the cross sectional area of the exhaust connection.
• All ducting, pipework and fittings must be made of non-
flammable materials.
• The exhaust ducting should be as short and straight as possible.
• Only use wide radius bends.
• The exhaust ducting should not be kinked or compressed.
• Ensure that all connections are strong and airtight.
• Where ducting is horizontal, it must be laid to slope away at least
1 cm per metre. This is to ensure that condensation cannot drain
back into the cooker hood.
• If the exhaust air is to be ducted into the open air, the installation of a telescopic wall vent or roof
vent is recommended.
• To avoid the danger of toxic fumes, please observe the Safety Warnings.
• This is especially crucial when using the cooker hood at the same time as another
heating appliance which relies on air from the same room.
• The cooker hood should be installed according to local and national building regulations.
Seek approval from the building inspector where necessary.
• If the exhaust ducting is to run through rooms, ceiling space etc. where there may be
great variations in temperature between the different areas, the problem of condensation
will need to be addressed. The exhaust ducting will need to be suitably insulated.
S60GHB13_S80GHB13IB.indd 16 10/06/2013 16:54