Sandstrom S5GONGW13, Инструкция по эксплуатации

Страница: 21 / 24

21
Conversion from NG to LPG or from LPG to NG
The replacement/conversion of the gas hob should only be undertaken by a Gas Safe
Registered Engineer. The hob is supplied for use with Natural Gas only and cannot be used
on any other gas without modification. It can be converted from NG to LPG or LPG to NG
providing the correct injectors are fitted and the gas rate is adjusted to suit.
Natural Gas
In the United Kingdom flexible connections must NOT be used for built in product, rigid or semi-rigid
pipework must be used.
LP Gas
In the United Kingdom flexible type hoses must NOT be used for built in products, rigid or semi-rigid
pipework must be used. Ensure it is suitable for use on LP Gas up to 50mbar pressure rise.
In all other countries this appliance must be installed in accordance with local regulations and standards.
Method
1. Ensure that the gas taps are in the Off ‘ ’ position
2. Isolate the hob from the electrical supply
3. Remove all pan supports, burner caps, rings, crowns and controls.
4. With the aid of a 7 mm box spanner the burner injectors can then be unscrewed and replaced by the
appropriate injectors. See the Burner Configuration Table for details. Note the size of the injector
being removed to ensure the corresponding size of the new injector is used, NG vs LPG.
Adjusting the Gas Rate
This unit has been set at the factory for NG but can be checked
after the correct pressure has been reached.
The bypass adjustment screw, which is located on the gas tap
body, can be adjusted with the aid of a thin bladed
screwdriver as follows:
1. Ignite the burner and set the control to its minimum position.
2. Remove the control. Also remove rubber seal if needed
to gain easier access.
3. FOR NG (G20 G25)
Rotate the screw slowly until a minimum regular flame is achieved.
(The flame will diminish when the screw is turned clockwise and
increase when turned anti-clockwise.
FOR LP Gas (G30 G31)
Rotate the screw fully clockwise – this is the fixed turn down position for LP Gas.