8
ENGLISH
This instruction manual contains important
information and must be read carefully by
competent persons prior to any handling, transport,
inspection or installation of this product. Every care
has been taken in the preparation of the
instructions and information; however, it is the
responsibility of the installer to ensure the system
complies with relevant national and international
regulations, especially safety. The manufacturer,
Soler & Palau Sistemas de Ventilación S.L.U.
accepts no responsibility for breakages, accidents
or any inconvenience caused by failure to comply
with the instructions contained in this manual.
The fans referred to in this manual have been
manufactured in accordance with rigorous quality
control and International standard ISO 9001. Once
the product has been installed, this manual to be
retained by the end user.
Transport and manipulation
The packaging used for this fan has been designed
to support normal transporting conditions. The fan
must always be transported in its original
packaging as not doing so could deform or damage
the product.The fan must always be transported in
its original packaging. Do not accept delivery if the
fan is not in its original packaging or shows clear
signs of having been damaged.
The product should be stored in a dry place in its
original packaging, protected from dust and dirt
until it is installed in its final location.
Do not place heavy weights on the packed product
and avoid impact damage.
Any lifting equipment must be safe and of suitable
capacity for weight and size. Special attention may
be required to ensure fan assembly does not distort
or tilt as weight distribution may vary. Never lift a
product by pulling it by the wires or terminal casing.
Likewise, no pressure should be applied on the
propeller, turbine or safety grid while manipulating
the product.
Important information for the safety of
installers and users
Installation must be carried out by qualified
persons acting in accordance with all
safety precautions applicable and as
required by law, regulations and standards
in the country applicable.
All fans are designed and manufactured in
accordance with EC Directive. Safety
guard accessories are available from S&P
if required due to specific installation.
Working ambient temperature for fan
equipment should not be exceeded
typically this will be within -20°C to +40°C,
unless stated otherwise.
This fan must not be used in explosive or
corrosive atmospheres.
If the fan is used in atmospheres with more
than 95% relative humidity, consult the
S&P Technical Service first.
If the fan is to extract air from premises
where a boiler or other combustion
appliance is installed, make sure that the
room has sufficient air intakes to assure
adequate combustion.
This appliance can be used by children
aged from 8 years and above and persons
with reduced physical, sensory or mental
capabilities or lack of experience and
knowledge if they have been given
supervision or instruction concerning use
of the appliance in a safe way and
understand the hazards involved. Children
shall not play with the appliance. Cleaning
and user maintenance shall not be made
by children without supervision
Safety during installation
Fan equipment should be electrically isolated
and locked out before any work started
Before any installation work is started, ensure that
fan equipment is correct for application. Location
for installation is solid, level, flat and suitable for
mounting fan assembly.
