Fig. 10
ductwork
Squeeze
lead wires
connectors
Note:
Fig. 9
Ensure the tap (Fig.2) in vertical position before installation.
Slide hanger bars onto housing and adjust as needed to fit between
framing. Extend the hanger bars to the width of the framing. Holding the
ventilator in place.Secure hanger bars to framing using one screw on each
end of hanger bar (refer to the right diagram).
Screw hanger bar to housing with screw A.
Distance A
14 in to 23 1/2 in (356mm-597mm)
19 11/16 in to 23 1/2 in (500mm-597mm)
Hanger Bar A
Hanger bar (short)
Hanger bar (long)
The choice of Hanger Bar A
Hanger bar A
ASSEMBLY INSTRUCTIONS
e. Wall installation with hanger bars only
Run 120V AC house wiring to the location of the fan. Use only UL-approved connectors (not included) to attach the house wiring to the
wiring plate. Refer to the wiring diagram, and connect the wires as shown.
CONNECT ELECTRICAL WIRING
FAN
WIRE
PANEL
UNIT
BLACK (BLK)
SWITCH BOX
FAN
POWER SUPPLY
120V AC
GROUND (GRD)
WHITE(WHT)
FAN
RECEPTACLE
2. Install ductwork and junction box
Remove junction box cover and secure conduit or stress relief to
junction box knock-out hole.Using connectors
,
connect house power wires to
ventilating fan wires (refer to wiring diagram) replace the junction box cover.
Squeeze the ductwork to fit the adaptor then slip onto the adapter and
secure it with duct tape (not included)
,
secure all the ductwork connections
so that they are air tight.
When the product is installed on the wall,the adaptor shall be faced upward.
3
WIRE
PANEL
UNIT
BLACK(BLK)
SWITCH BOX
FAN
POWER SUPPLY
120V AC
GROUND (GRD)
BROWN(BRN)
WHITE(WHT)
FAN
RECEPTACLE
FAN
SWITCH B
SWITCH
OX
HUMIDITY SENSOR /
HUMIDITY SENSOR /
SPEED CONTROLLER
HUMIDITY SENSOR /
SPEED CONTROLLER
HUMIDITY SENSOR /
SPEED CONTROLLER
SWITCH
CONTROLLER RECEPTACLE
For model: PCLP50 , PCLP80 and PCLP100
For humitidy sensor and speed controller function
