6
Removing Card
To remove the card in Windows:
1. Double click on the icon "My Computer"
2. Right-click on the corresponding ImageMate 12-in-1 Reader/Writer drive icon
3. Select Eject (this is not needed for Windows 98SE or XP)
4. Pull the card out of the slot
To remove the card on a Macintosh:
1. Drag the “untitled” icon into the Trash
2. Pull the card out of the slot
Disconnecting
You don’t need to shut down your computer to disconnect the ImageMate 12-in-1 Reader/Writer, but you
should
NEVER
remove the device from the USB port without first reading the steps below. If a drive
window is open or the ImageMate 12-in-1 Reader/Writer is active, close any associated windows before
attempting to remove the ImageMate.
Windows
Use the hotplug icon in the notification area of the taskbar to safely stop the device
before unplugging it. The notification area is on the right side of the taskbar where you
usually see the time displayed.
These steps are not required for Windows 98SE or XP
1. In the notification area, right-click on the hotplug icon
2. Select the device you want to unplug then click
STOP
3. When Windows notifies you that it is safe to do so, unplug the ImageMate 12-in-1 Reader/Writer from
your computer
Macintosh
1. Drag the ImageMate 12-in-1 Reader/Writer “untitled” icon into the Trash.
2. Unplug the device.
Troubleshooting
For FAQs on error messages please go to our website at
http://www.sandisk.com/retail/support.asp
For assistance by phone please call toll free 866-SANDISK (866-726-3475) M-F 7AM till 4 PM PST (you
can find local European phone numbers at
www.sandisk.com
)