Sandia Spot-Xtract, Руководство пользователя

Страница: 7 / 9

Extractor will not run:
Problem Solving
ƒ
Check power connection. Move the grounded plug to an outlet that is
working. Verify that the plug is working by plugging in another electrical
component such as lamp, hair dryer or drill.
ƒ
Inspect the power cord for damage.
Loss of vacuum:
ƒ
Make sure the float is at the bottom of the unit. Open the screw cap and
push the float down.
ƒ
Check that hose cuff is securely attached to the front of the extractor.
Loss of solution pressure:
ƒ
Verify that the pump is on.
ƒ
Remove jet from end of hand tool and press trigger on wand.
ƒ
Clean the solution intake in the solution tank.
ƒ
Check the quick-disconnect for debris.
ƒ
If pump is still not working, contact dealer.
Page 7
Caution: Electrical wire colors may vary.
Determine start and end point of each wire to
confirm connection point.
SPOT-XTRACT
WIRING DIAGRAM
1234567890123456789012345678901212
1234567890123456789012345678901212
1234567890123456789012345678901212
1234567890123456789012345678901212
1234567890123456789012345678901212
1234567890123456789012345678901212
1234567890123456789012345678901212
1234567890123456789012345678901212
1234567890123456789012345678901212
1234567890123456789012345678901212
1234567890123456789012345678901212
Black
Blue
Vacuum
Motor
White
Green
Blue
Blue
Black
A/C
Power Cord
Switch
1234567890123456
1234567890123456
1234567890123456
1234567890123456
1234567890123456
1234567890123456
1234567890123456
1234567890123456
1234567890123456
1234567890123456
1234567890123456
1234567890123456
1234567890123456
1234567890123456
Pump
Blue