SandenVendo V21 521, Руководство по обслуживанию

Страница: 235 / 257

V21 Parts & Service Manual
All V21 Identified Equipment
REV A – 10/2013
P/N: 1230468
DETAILED REFRIGERATION CYCLE
The following is a detailed refrigeration cycle as it applies to the refrigeration system installed in
SandenVendo America, Inc. equipment. (Refer to the flow chart in Figure 1.)
As the air temperature in the cabinet rises, the electronic temperature sensor reports the air
temperature to the electronic controller. The electronic controller actuates the refrigeration
control relay, which turns on both the compressor and condenser fan motor.
The evaporator fan pulls air from the front of the refrigerated space of the cabinet. It pulls the
air through the evaporator, and blows it up the rear of the vend stack. (The evaporator fan runs
continuously.) As the air passes through the evaporator, heat is drawn from the air and
transferred to the liquid refrigerant. As the cooled air circulates through the vend stack, heat is
drawn from the product and transferred to the circulating air. The heated air is again drawn
through the evaporator where the heat is removed.
In the evaporator, the liquid refrigerant draws heat from the circulating air. As refrigerant
receives heat, it vaporizes.
The compressor pumps the vapor from the evaporator and compresses it, increasing both
pressure and temperature. The compressor forces the compressed vapor out, through the
discharge line and into the condenser.
The condenser fan pulls air through the condenser. As the hot refrigerant vapor passes through
the condenser tubes, heat is drawn from the vapor. This heat is dissipated into the passing air.
The air then exits out the back of the vendor. As the refrigerant vapor in the condenser lines is
cooled, it returns to a liquid state.
From the condenser the liquid flows to the drier. The drier removes any water and solid particles
from the liquid refrigerant.
The cooled liquid refrigerant continues from the drier, through the capillary tube, to the
evaporator. The capillary tube steadies the flow rate of the refrigerant. Its small inside diameter
allows the pressure in the evaporator to remain low while the pressure in the condenser is high.
The cool refrigerant in the evaporator draws heat from the circulating air in the cabinet. As the
temperature in the cabinet drops, the electronic temperature sensor reports the air temperature
to the electronic controller. The electronic controller deactivates the refrigeration control relay,
which turns off the compressor and condenser fan motor.
When the air temperature in the cabinet rises above the electronic controller’s cut in setting, the
compressor and the condenser fan engage again.
V21
Maintenance | M-5