Instructions for the installer, maintenance
technician and final user
Page 26 of 33
© SandenVendo Europe SpA
4.2.4 Products Charging
Attention!
Never load the vending machine with products different to those recommended by the
manufacturer.
Attention!
Never load the vending machine with product formats different from those recommended by
the manufacturer.
Attention!
Follow the manufacturer's instructions regarding the expiry dates of the products and the
maintenance temperature.
Attention!
To avoid problems, the operator in charge of filling the vending machine must not activate the
safety switch.
For loading operations, follow the instructions below:
Open the vending machine door;
Remove one tray at a time, slightly lift the tray and pull outwards until it reaches the
locking point. The tray would tilt downwards facilitating the loading;
Proceed with the loading of the products starting from the inner parts (motor side) until
reaching and completing the spaces of each spiral.
Attention!
When not all the spiral slots are filled, it is recommended to load the products starting from the
front of the tray inwards.
Attention!
The bottom of the product must rest on the bottom of the compartment with the label facing
the window so that it is recognizable.
Attention!
Use the appropriate accessories for the loaded product.
Attention!
When filling the spirals, check that the products are not too tight in their housing. Do not force
the insertion of the products into the slot of the spirals because the product must slide out
thanks to its weight. If necessary, replace the spiral with one with a larger step;
Attention!
Avoid placing products whose edges can get in the way during sliding.
Put the tray back inside of the vending machine and make sure that the connection has
taken place;
Close the vending machine door and wait for the parameter configuration reset check..
Common products are normally tested at the factory. Ask for the setting number of the
product you want to sell and refer to this number when ordering. We will make the
vending machine according to your specifications.
