SAN YUAN CV, Инструкции по техническому обслуживанию и эксплуатации

Страница: 11 / 14

- - 10
MOTOR TROLLEY
CAUTIONS FOR THE USE OF MOTOR TROLLEYS
1. Before mounting the motor trolley on the I-beam, the width of I-beam must be
measured. As shown in the following diagram, adjust the clearance between the two
wheels of the trolley to the correct position. Then, mount it onto the I-beam and tighten
the nuts at two ends.
TYPE MEASURE MENT OF I-BEAM ADJUSTING THE POSITION OF THE WASHER
1/4~1MT
I
150 Χ 75 Χ 5.5
2~3MT
I
200 Χ 100 Χ 7
5MT
I
250 Χ 125 Χ 7.5
1/4~1MT
I
200 Χ 100 Χ 7
2~3MT
I
250 Χ 125 Χ 7.5
5MT
I
300 Χ 150 Χ 8
1/4~1MT
I
250 Χ 125 Χ 7.5
2~3MT
I
300 Χ 150 Χ 8
5MT
I
450 Χ 175 Χ 11
2. The paint on the contact surface of the moving wheel and I-beam must be removed.
Otherwise, the wheel will run idle, interfere with the grounding connection and cause
electrostatic charge.
3. The gear of the moving wheel with gear must be regularly oiled
（
use normal grease
）
.
But do not oil the wheel surface and I-beam. Otherwise, it will run idle and perform no
movement.
4. Check if the pressure plate is bent, deformed, the coating surface of the electrical
cable is aged, damaged or disconnected.
5. Check if the bolts, nuts and snap rings are loosened or disengaged.