San Juan Yachting Mariah, Записи владельца

Страница: 29 / 35

5/7/20
29
SALON SETTEE CONVERSION TO A BED
To convert the salon settee to a double bed, move the table to the port side of the salon.
Lift the front side of the settee about 6” and smoothly pull it toward the center of the salon.
Note that on your right side as you pull out the bed there is a space in the teak trim. That space
is the extension limit, the trim board you are pulling on fits into that space. There is also a metal
tab that fits into a slot to stabilize the bed. IMPORTANT: On the left side underneath the pullout
bed is a SUPPORT LEG. To extend the leg, reach in and you will feel a small lever on the right
side of the leg. Pushing on this lever will release the leg and you can place it in position to
support the bed. To stow the leg, lift the bed slightly and push the lever again and move the leg
to its folded position. When the bed is pulled out and the support leg is in place, you can
remove the backrest and place it into the space created by pulling the bed out. The backrest is
held on with velcro and two slotted pins. Pull out on the bottom of the backrest to release the
velcro then lift both sides of the backrest about an inch and pull gently towards you to release
the pins. When detached, slide the backrest in along the starboard sidewall of the boat in order
to make a wider bed. Reverse this procedure to return the backrest to the settee configuration.
A mattress pad and additional blankets will be stored under the seat cushion in the office
station, or under the large settee cushion in storage compartments. Advise San Juan Yachting
staff if you plan on using the salon settee as a bed and they will provide additional linens.
PILOT HOUSE SETTEE CONVERSION TO A BED
The pilot house settee can be configured as a single bed using the following procedure.
1. Remove the small table. Grasp the table and pull up while moving it slightly from side to
side. Once free set it upside down on the floor out of the way.
2. Both backrests are held in place with Velcro. Remove them and stow the smaller one
with the table and place the longer one on the adjacent counter top with the thicker
part to the starboard side of the boat.
3. There are 2 grey colored spacers in the tip-up step on the settee. Place the spacers
under the thinner side of the backrest to make it level with the seat cushion.
4. Last step is to lift the aft side of the bottom seat cushion so that the hinged wedge will
drop down in place and make the seat cushion level with the backrest providing a
continuous level surface for sleeping. Advise SJY staff if you plan on using this settee as
a bed and they will provide extra linens etc.
THE FOLLOWING PANEL PICTURES AND EXPLAINATIONS WILL BE HELPFUL IN
AQUAINTING YOU WITH MARIAH'S SYSTEMS AND OPERATIONS.
PILOT HOUSE CB PANEL
NOTE:
1) The DC Refrigerator breaker is for the 12 volt freezer on the top deck.
2) Leave the Video Camera, Freezer, Fuel Transfer, and windless breakers off unless you intend to use them.
3) Leave the five guarded breakers on the upper right panel on at all times. Never use these breakers to
turn off the associated equipment or damage to the various systems will result.
Use the individual component on/off buttons.