5.14 Set up Panic Report
Use this command to set up the frequency of Panic Report. If you send the SMS according to the
example shown below to CT-58A, you will have a Panic Report Message every 300 seconds for 99
messages. Once the loop is done, you can send a SMS message to update/ renew, or switching off it in
order to renew it.
Note
: You may limit the amount of the Panic reply messages by inputting the digits from 1 to 9998
in the
「
total number of report
」
field. When you input 9999, the Panic Report Message will not stop
unless you define a new Panic Report Setting.
Setup format
＃「
username
」
,
「
Password
」
,
「
Function Code
」
,
「
intervals (sec)
」
,
「
total number of report
」＊
Example1
：＃
username,0000,15,300,99
＊
The table 5.14.1 describes the meaning of each segment in the message above.
Table 5.14.1
The table 5.14.2 shows each confirmation message reply after setup
Table 5.14.2
Text Keyed In SMS Description
#
Start sign.
username
Default ID of CT-58A.
If you have changed the Username, please use the updated one.
0000
Default password.
If you have changed the password, please use the updated one.
15
Mode 15 defines to change the intervals and times of the Panic report
300
A constant interval of sending data
99
The amount of 99 messages will be sent automatically
*
End sign.
Situation
Message Reply
Setup Succeeds
[username] + Setup OK. Device Panic report setting is
updated.
Setup Fail
[username] + Panic report setting Setup Fail!
Incorrect password
[username] + Password setup Fail!
Incorrect username or command
format
[username] + command error
CT-58A is in Emergency Mode
[username] + in emergency, Auto Report setting is not
allowed.
