Figure 5
Страница 1: ...old the tool so that the front side is facing you 2 Ensure that the tool ratchet is released by squeezing the tool handles and allowing them to open fully 3 Holding the contact by its mating portion and looking straight into the crimp section insert the contact from the back of the tool into the appropriate crimp chamber 4 Position the contact between the crimpers so that the locator insulation st...
Страница 2: ... it is recommended that the tool be inspected immediately upon its arrival at your facility to ensure that the tool has not been damaged during shipment 1 Remove dust moisture and other contaminants with a clean brush or a soft lint free cloth Do not use objects that could damage the tool 2 Make certain that the retaining pins are in place and that they are secured with retaining rings 3 All pins ...
Страница 3: ...25 mm 001 in shim that is suitable for checking the clearance between the bottoming surfaces of the crimping dies Proceed as follows Proceed as follows 1 Select the maximum size wire and strip it according to the dimensions listed in the drawing shipped with the tool 2 Select the contact and crimp section corresponding to the selected wire size refer to the drawing shipped with the tool 3 Position...
Страница 4: ...Figure 5 ...
