10 _ Removal and Reassembly
3-2. STANDARD DISASSEMBLY DRAWINGS
► This is a standard disassembly diagram and may differ from the actual product.
Use this material as a reference when disassembling and reassembling the product.
Part
Figure
Description
Disassembling and
Repairing the Rear
Motor
1. Remove the 4 screws holding the Back-Cover at
the back of the washing machine and separate the
Back-Cover pushing it downwards.
(Assemble it by lifting it upwards)
2. After separating the Back-Cover, remove the M19
nut holding the Motor.
To remove it, turn it counter-clockwise. As the
Motor also rotates if the nut is turned slowly, torque
it quickly and firmly in a single action.
Do not remove the nut by inserting a screwdriver
into the Motor, as this may result in a problem with
the motor.
3. Remove the M19 nut and washer and then
separate the Rotor.
Since removing the rotor requires a lot of strength
due to the magnetic force of the Rotor and it
may come off suddenly, your hand or arm may
be injured by the edge of the Stator or Frame.
Therefore take precaution when separating it.
You can separate the connector by pressing.
4. Separate the Motor Wire while pressing the navel
of the Housing.
5. Separate the 6 M10 screws. → Separate the Assy
Bracket Motor → Separate the Stator.
When removing the last of the 6 screws, hold the
Stator as it may fall when the screws are removed.
﹡
Check Points for Troubleshooting
1. 1. Check if there is any alien substance between the Rotor and the Stator.
2. Check if the motor power (Blue, White, Red) wire is connected
The order of the motor wires is Blue, White, and Red from the right. Check if the
resistance between Blue-White, White-Red, and Red-Blue is equal to 15Ω.
