# tsWF331 09/30/2011 6
When installing a washer and dryer on
the first, or second floor, do not exceed
this leg adjustment height for stability.
Error Type
Error Mode
Details
LED LCD
Heater Error
Hr
(Heater
Relay)
This can be a short or a wire disconnected to the heater circuit. This
can also be problem with the tub contacting the heater or if the wa-
ter in the tub is frozen or there is no water. The error is triggered by
temperatures above 145C. If the heater has no error, this occurs
because of a PBA relay malfunction. Check the wiring harness to
the heater.
An Hr error occurs if the steam heater, is faulty, replace it.
Overflow error
OE
1E
Water is supplied continually because the water level detection
does not work. - Verify the drain is working properly, the water level
detection does not work and water is supplied continually. Verify the
water valves shut off fully. Finally check the water level sensor.
Temperature
Sensor Error
tE1
The washing heater temperature sensor in the tub has an error.
Check the connections for the washing heater temperature sensor
connector.
Unbalance
Error
dC
Check the type of laundry. Check whether it may cause an unbal-
anced situation.- Educate the consumer in this case, to press
pause, reposition the load or remove a few items. Press start to
continue and complete the wash cycle.
Clutch
Motor Error
PE
Check the clutch motor
windings and connec-
tor.
Clutch motor error. Occurs when the clutch motor position
is not detected.
The MICOM will attempt 3 times to
determine the motor position. After the
3
rd
attempt the error will appear.
Clutch motor error. Occurs when the clutch motor position
is not detected.
Check whether the washing machine is level to the floor with respect to the original position of the washing machine prior
to service. Doing this now will reduce the need for a redo call and customer dissatisfaction.
✔ Vibrations can shorten the lifetime of the product.
Mems or Har-
ness Failure
8E
Check MEMS PCB ,Main PCB & Wire-harness
MEMS sensor error. If the output from the MEMS sensor is
over 4.5VDC
(open) or below 0.5VDC (shorted) for 5 seconds this error will occur.
Foaming
Detected
SUdS
Sd
This occurs when too much foaming is detected. It is also displayed
while foaming is removed. When the removal is finished, the normal
cycle proceeds. (This is one of the normal operations. It is an error
for preventing non-sensing faults.)
Clutch assem-
bly hall sensor
error
PE1
Check the clutch hall
sensor and wiring.
Clutch assembly hall sensor error. The drum will shake to
try to determine
if the clutch is in the right position. After 15
attempts if the hall sensor is not
communicating with the
MICOM the error will occur.
www.mosogepszerviz.info
