Version 1.0
Samsung Electronics
page 4 of 5
4. Notice
This device complies with Part 15 of FCC Rules. Operation is Subject to following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received including interference that cause undesired operation.
This equipment has been tested and found to comply within the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna
•
Increase the separation between the equipment and receiver
•
Connect the equipment into an outlet on a different circuit from that to which the receiver is
connected
•
Consult the dealer or an experienced radio/TV technician for help.
The transmitter must not be co-located or operated in conjunction wit any other antenna or transmitter.
The available scientific evidence does not show that any health problems are associated with using low power
wireless devices. There is no proof, however, that these low power wireless devices are absolutely safe. Low power
wireless devices emit low levels of radio frequency energy (RF) in the microwave range while being used. Whereas
high levels of RF can produce health effects (by heating tissue), exposure to low-level RF that does not produce
heating effects causes no known adverse health effects. Many studies of low-level RF exposures have not found any
biological effects. Some studies have suggested that some biological effects might occur, but such findings have not
been confirmed by additional research.
To satisfy RF exposure requirements, this device and its antenna(s) must operate with a separation
distance of at least 20 centimeters from all persons and must not be co-located or operated in conjunction with any
other antenna or transmitter. End-users must be provided with specific operating instructions for satisfying RF
exposure.
FCC WARNING:
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s
authority to operate the equipment
According to FCC 15.407(e), the device is intended to operate in the frequency band of 5.15GHz to
5.25GHz under all conditions of normal operation. Normal operation of this device is restricted to indoor
used only to reduce any potential for harmful interference to co-channel MSS operations.
. Information for OEM Integrator
The OEM integrator has to be aware not to provide information to the end user regarding how to install or remove this
RF module in the user manual of the end product.
The user manual which is provided by OEM integrators for end users must include the following information in a
prominent location.
“To comply with FCC RF exposure compliance requirements, the antenna used for this transmitter must be co-located
or operating in conjunction with any other antenna or transmitter.
If the end product integrating this module is going to be operated in 5.15~5.25GHz frequency range, the warning
statement in the user manual of the end product should in clued the restriction of operating this device in indoor could
void the user’s authority to operate the equipment.”
Label for end product must include “Contains FCC ID: WDF710Q” or “A RF transmitter inside, FCC ID: WDF710Q”
