Samsung WA95F3, Руководство пользователя

Страница: 11 / 28

- 11 -
■
ASSEMBLING THE RAT PROTECTION PANEL
■
HOW TO CONNECT THE DRAIN HOSE
☞
IN CASE OF PUMP-DRAINED WASHER
☞
IN CASE OF GENERAL WASHER
HOW TO CHANGE THE DRAIN HOSE DIRECTION
•
The handle of joint ring is pressed to pull out the
drain hose. Change the direction of the drain
hose and follow the above guideline again.
CAUTIONS WHEN INSERTING THE DRAIN HOSE
Tilt the washer a little and lift up the panel until it clicks, finally fix the panel
with screw to the base as shown in the figure.
1. Insert the sound absorbing panel to the assembling
hole on back side to the end
2. If you have difficulty inserting the panel lift up the washer
a little and insert it.
Take out the cap-hose and
connect the outlet-hose. Be sure to join tightly the drain hose into
the drain-outlet on the back of the
machine.
Be sure to join tightly the drain
hose into the drain-outlet on
the side of the machine. Install the drain hose in the position of
about 90~100cm above the ground.
Rear-side
90~100cm
1. After pressing the joint ring, insert to the drain
hose.
2. After directing the drain hose to a drain, join to
the drain-outlet of the washing machine.
3. Be sure to join them tightly by pressing the joint
ring and pushing it into the drain-outlet.
•
The length of drain hose is adjustable so that
you can extend the length appropriately.
1. Don’t exceed more than 3m when the
drain hose is used by connecting whth
other hoses.
2. Be careful to drain water out at the end of
the drain hose.
3. The doorsill shoudn’t be more than
5cm.
4. Don’t install the drain hose underneath
the wash machine.
drain-outlet
Less than 3m
Less than 3m
Less
than 5cm