troubleshooting
_29
PROBLEM
SOLUTION
Fills with the wrong
temperature water.
•
Turn both faucets on fully.
•
Make sure the temperature selection is correct.
•
Make sure the hoses are connected to the correct faucets.
Flush water lines.
•
Disconnect the hoses and clean the screens. The hose filter screens
may be plugged.
•
As your Washer is filling, the water temperature may change as
the automatic temperature control feature checks incoming water
temperature. This is normal.
•
While your Washer is filling, you may notice just hot and/or just
cold water going through the dispenser when you have selected
cold or warm wash temperatures. This is a normal function of the
automatic temperature control feature as your Washer determines the
temperature of the water.
Door locked or will not
open.
•
Press the Start/Pause Button to stop your Washer.
•
It may take a few moments for the door lock mechanism to
disengage.
Does not drain and/or spin.
•
Check the fuse or reset the circuit breaker.
•
Straighten the drain hoses. Eliminate kinked hoses. If there is a drain
restriction, call for service.
•
Close the door and press the Start/Pause Button. For your safety,
your Washer will not spin unless the door is closed.
Load is too wet at the end
of the cycle.
•
Use the High or Extra High spin speed.
•
Use high efficiency detergent to reduce over–sudsing.
•
The Load is too small. Very small loads (one or two items) may
become unbalanced and not spin out completely.
Leaks water.
•
Make sure all hose connections are tight.
•
Make sure the end of the drain hose is correctly inserted and secured
to the drainage system.
•
Avoid overloading.
•
Use high efficiency detergent to prevent over–sudsing.
Has excessive suds.
•
Use high efficiency detergent to prevent over-sudsing.
•
Reduce the detergent amount for soft water, small or lightly soiled
loads.
•
Non-HE detergent is NOT recommended.
05 tr
oubleshooting
WA5471ABP-03050B_EN.indd Sec10:29
WA5471ABP-03050B_EN.indd Sec10:29
2012-01-12 5:24:20
2012-01-12 5:24:20
