9
WATER SUPPLY CONNECTOR FILTER
2. Pull in the filter and connect
the hose to the inlet water
valve tightly.
inlet water
valve
3. Check if there is a leakage.
Note to tighten up the
connector.
1.Pull out the filter and wash well.
How to level
Level it by adjustable legs.
Adjust the height by using the adjustable rubber
or prop at the back.
Adjust the left part by using the adjustable legs
at the front and the adjustable rubber at the back.
Adjust the right part of the washer by using the adjustable leg
at the front and the adjustable rubber at the back.
Cause
The front part is
lower
The back part is
lower
The left part is
lower
The right part is
lower
Waterdrop mark
●
Adjust the height control legs to make eve.
●
After slightly lifting up the machine, rotate the
adjustable leg counter-clockwise and pull
as much as need to adjust the reight.
●
After putting down the machine after adjustment.
●
Adjust the height and secure.
●
Secure the lock nut by rotating it firmly.
●
If the lock nut is not secured, the adjustable
leg may be released.
Adjustment of height
If not leveled, adjust the legs to level the washer.
●
Be careful not to put in your hand under the legs.
(It may cause some injury)
LOCK
UNLOCK
LOCK
UNLOCK
LOCK
UNLOCK
Lock Nut
Adjustable
Leg
Unlock
Unlock
Lock
Lock
Pull the handles located at the
right and left of the front side
and slide off.
Adjust the water drop mark to
be in the red circle pulling back
the machine slightly, and then,
push it with a feet to fix.
Fix the handles by hand
completely.
LEVELLING
●
If the washer is not leveled with the ground, it makes the machine tremble more or
be out of order. So, make sure that the washer is leveled properly.
220V-10kg-01518V 6/18/02 5:56 PM Page 10
