20 English
Ins
tallation
Installation
STEP 6
Running a test cycle
Run a test cycle as follows to check if your washer is properly installed.
1.
Load about 6 pounds of laundry into the tub.
2.
Press
Power
to turn on your washer.
3.
Press
Rinse+Spin
on the Cycle panel.
4.
Press and hold
START/PAUSE
to start the test cycle.
5.
The washer should not rock or vibrate excessively when water is supplied or when
washing or spinning, and should drain well during the spin cycle.
NOTE
If water leaks while water is being supplied or drained, check the water connections. Refer to
the
"STEP 3 Connect the water hose"
section on page
for instructions.
NOTE
If the washer rocks and vibrates excessively, level your washer again. Refer to the
section on page
for instructions.
STEP 7
Calibration Mode
Your Samsung washer detects the laundry weight automatically.
For more accurate weight detection, please run Calibration Mode after the installation.
To run Calibration Mode, follow these steps:
1.
Remove laundry or any contents in the machine.
2.
Press and hold
Temp.
and
Delay End
simultaneously for at least 3 seconds when the
power is turned on.
3.
Press and hold
START/PAUSE
to activate Calibration Mode.
4.
The pulsator rotates clockwise and counterclockwise approximately 1 minute.
5.
When Calibration Mode is finished, “
0
” appears on the display, and the washer
automatically turns off. The washer is now ready for use.
WA8700K(HEATER)_DC68-03520W-02_EN.indd 20
2018-05-15 5:43:36