9
WATER SUPPLY CONNECTOR FILTER
2. Pull in the filter and connect
the hose to the inlet water
valve tightly.
inlet water
valve
3. Check if there is a leakage.
Note to tighten up the
connector.
1.Pull out the filter and wash well.
How to level
Level it by adjustable legs.
Adjust the height by using the adjustable rubber
or prop at the back.
Adjust the left part by using the adjustable legs
at the front and the adjustable rubber at the back.
Adjust the right part of the washer by using the adjustable leg
at the front and the adjustable rubber at the back.
Cause
The front part is
lower
The back part is
lower
The left part is
lower
The right part is
lower
Waterdrop mark
•
When a proper amount (one time does) of fabric
softener is stored in the softener inlet,it is
automatically put in at the last rinsing cycle.
•
Do not use detergent, bleach or starch into
the Softener Inlet.
•
Using too much softener may produce
unsatisfactory results.
•
Do not open the lid during the Spin Dry cycle.
If added too early, its effectiveness will decrease.
•
Do not leave the softener
into the Softener
Dispenser for a long time.
Because softner
became stiff.
1
.Open the detergent box by pulling in the direction of the arrow as shown in the
figure and then put the powder detergent in the detergent box.
2
. Put in one-time amount of detergent evenly so the detergent may not brim over the box.
HOW TO PUT THE DETERGENT IN AND ADD THE FABRIC SOFTENER
Detergent Device
Put the detergent
in proportion to
water level
CAUTION :
If softener is stored over the above base line, it may flow down at any time.
Softener Device
Softener
baseline
Softener Device
gb-ar-10kg-01320J 10/10/01 1:54 PM Page 10
